An electrical designer is creating an electrical fixture family for a receptacle. The designer nests a generic annotation family that contains the receptacle symbol and a label What must be done in the electrical fixture family so that the label value can be changed in a project?

• A. Enable Shared in the generic annotation family and re-load it into the fixture family.
• B. Associate the nested family's parameter to a parameter in the electrical fixture family.
• C. Create a label and use a formula to set it equal to the generic annotation label.
• D. In the Visibility Settings for the nested generic annotation, select Label.

A project is almost at the end of design. The electrical designer needs to make sure electrical loads as reported by load summaries accurately reflect all modeled loads. How should a designer view a list of all modeled electrical connectors that are not connected to a circuit?

• A. Use the command Check Circuits.
• B. Create a circuit schedule.
• C. Review the System Browser.
• D. Use the command Show Disconnects.

What two ways can an electrical designer copy a cable tray type from a project to a template? (Select two.)

• A. 1 Open both the project and the template in the same Revit session.
  2. In the template, activate Transfer Project Standards.
  3. Choose to copy from the project and then select Cable Tray Types.
• B. 1. Open both the project and the template in the same Revit session.
  2. In the project, copy the cable tray to the clipboard.
  3. Switch to the template and paste the cable tray in a view.
• C. 1. Open the project and the template in separate Revit sessions.
  2. In the template, activate Transfer Project Standards.
  3. Choose to copy from the project and then select Cable Tray Types.
• D. 1. Open the project and the template In separate Revit sessions.
  2. In the project, copy the cable tray to the clipboard.
  3. Switch to the template and paste the cable tray in a view.
• E. 1. Open both the project and the template in the same Revit session.
  2. In the project, select the cable tray and click Edit Family.
  3. Click Load into Project and select the template to load the family into.

Refer to exhibit.

Which two actions were used to create this light fixture schedule? (Select two.)

• A. Deselected Itemize every instance.
• B. Sorted by instance and quantity.
• C. Sorted by type mark.
• D. Filtered to only show lights that have a type mark value.
• E. Added both electrical and switch system settings.

An electrical designer has created a family and loaded It Into the project. The designer wants to connect the family to a power circuit but the Power icon is not available when the family Is selected.
How should the designer fix the problem?

• A. Set the family parameter to Shared.
• B. Change the Voltage parameter value to non-zero.
• C. Add an electrical connector to the family.
• D. Set the distribution system for the family.